System Clock; Optional - Lorex LN Series Instruction Manual

Settings

System Clock

You may need to change the time zone depending on your region, and daylight savings (DST)
settings. You must manually configure your camera when your daylight savings settings change.
To configure the system clock:
1. Select the box to enable/disable Network Time Protocol (NTP). NTP automatically sets the
system clock using a Network Time Server. By default, the NTP server is enabled.
NOTE: The Network Time Protocol (NTP) is a protocol for synchronizing the clocks of computer systems
to a central time server.
2. Under NTP Server Address, enter the address of the NTP Server. The default setting is
ntp.lorexddns.net, however any other NTP server can be used if desired.
3. Under Time Zone, select the time zone to the local time from the drop down menu (GMT -12 ~
GMT+0 ~ GMT +12).
4. De-select the checkbox beside "Use Network Time Protocol to set the system Clock." and
then re-select the checkbox to save your settings.

OPTIONAL:

1. Click Set System Time, to set the time on the camera to the local time on your PC. This will
disable the NTP server.
2. Click OK in the confirmation window. Please allow a few moments for your camera to update.
Figure 20.1 Set time on the device to the local time on your PC
72