Wireless; Wireless Settings - Lorex LN Series Instruction Manual

Wireless

ATTENTION: This section is applicable to LNE3003 and LNZ4001 camera models
& LNZ4001 are B/G wireless devices. N wireless routers must be in "mixed B/G" mode (not in N mode)
to detect the camera.
Use the Wireless menu to configure wireless networking options for your wireless cameras.
DigiViewer supports OPEN, WEP, WPA, and WPA2 encryptions.
To open the Wireless menu:
>
• Click Settings

Wireless Settings

To configure wireless settings:
1. Under Wireless Mode, select Enabled
from the drop-down menu. DigiViewer
will scan for available wireless
networks.
2. Select a network from the list. Options
will vary depending your wireless
network—these options are
automatically filled in.
• Network Name (ESSID): The name of
the selected wireless network
• Current Status: Displays Connect/Not
Connected
• Mode: Displays Managed or
Unmanaged depending on your
network
• Authentication: Will display OPEN or
WPA depending on your network
• Encryption: Displays encryption styles
3. Under WPA/WEP Password, enter the password required to access your network.
4. Leave the box selected to use DHCP to set the Network Address (default). Go to step 5. If you
want to set your own static wireless network information, deselect this box and go to step 4.
5. OPTIONAL—enter your static wireless networking information in the following fields:
• IP Address: The wireless IP address for your wireless device
• Network Mask & Gateway: The numeric addresses assigned to the Network Router
• Name Server 1 & 2: The external IP address of the Name Server. The Name Server is a
machine on a network that enables a hostname to be resolved into an IP address. (i.e.
www.lorex.com translates to IP Address 207.97.199.227)
6. Click Submit Wireless to save your settings. Please allow a few moments for your camera to
update.
For more details, see "Setting Up Wireless Connectivity" on page 30.
80
Wireless
Figure 24.0 Wireless menu
only . The LNE3003