Removing Services Using DigiViewer
You can also remove all Yoics services registered to your camera using DigiViewer.
To remove Yoics servics using DigiViewer:
1. Log in to the camera through Digiconsole, or click on Start>Network (on Windows Vista/7),
and double-click the name of your camera. Enter the camera's user name and password to
log in (default username: admin ; default password: admin).
2. Click Settings> Remote Access.
3. Under Yoics Instant Networking, click Reset. Please allow a few moments for DigiViewer to
update, then refresh the browser.
• Under Yoics, a message will read "
has now been remove from Yoics service.
NOTE: Press F5 on your keyboard to refresh the page.
NOTE: Performing a hard reset of your camera will also remove all Yoics services registered to your
camera. For details, see "Appendix J: Rebooting, Resetting, and Recalibrating the Camera" on page 113.
Resetting Yoics Services
If you remove Yoics services using DigiViewer or due to a hardware reset, you can quickly reset
the services from the Yoics website.
To reset Yoics services:
1. In your browser, go to www.yoics.com and log in using your Yoics ID and password.
2. A pop-up will alert you to the fact that Yoics remote viewing services have been removed from
your camera. Click Reset Service.
Figure 39.9 Rest Yoics service
3. Repeat step 2 for remaining Yoics services.
Appendix K: Registering, Removing, and Resetting Yoics Services
: Register this camera". Your camera
Yoics is not initialized
119