Entering Http Event Information - Lorex LN Series Instruction Manual

4. Click SET to open the Preset/Patrol Control pane.
Figure 37.1 Click Set
5. Click Set to save the position as a preset.
Entering HTTP Event
Information
With your preset saved, you must now
enter the network information for
Camera A as an HTTP Event.
To set an HTTP event:
1. From DigiViewer, click Events and
then click HTTP Event.
1. Under General HTTP Event, select
Enable HTTP event.
2. Under URL, enter the URL/DDNS
domain of Camera A followed by /
cgi-bin/operator/ptzset. For
example, 192.168.0.122:81/
cgi-bin/operator/ptzset
3. Enter the Port number, user ID
and password of Camera A.
4. : If using a proxy server,
Optional
enter the proxy server name, port,
user name, and password in the
fields.
5. Under Alarm Sending Event,
select Enable Alarm Sending Event.
6. Select Enable Alarm Motion Detection.
7. Enter the following parameter: gotoserverpresetname=[Preset#]. For example,
gotoserverpresetname=Preset1. Make sure you enter the preset name EXACTLY as it appears
in the Preset list (Settings
8. Select Enable Alarm input.
9. Enter the following parameter: gotoserverpresetname=[Preset#]. For example,
gotoserverpresetname=Preset2.
10. Click Submit HTTP Event to save your settings.
Figure 37.2 Completed HTTP Event and Alarm Sending Event fields
>
Preset).
Appendix I: Setting Up HTTP Events
111