Connecting The Camera - Lorex LN Series Instruction Manual

CONNECTING THE CAMERA

With the camera assembled, you can now connect the power and network cables.
To connect the camera:
1. Connect the included Ethernet cable to the Ethernet port on the rear panel of the camera.
2. Connect the other end of the Ethernet cable to a network router, switch, or active wall port.
NOTE: For a wireless connection, the camera only needs to be wired to your network for initial setup and
configuration. Once the camera is fully setup, you can disconnect the Ethernet cable and connect to your
network wirelessly.
3. Connect the power adapter to the camera.
4. Plug in the power adapter to a power outlet.
LNZ4001
LNE1001
Figure 3.0 Wired connection (wired connection only needed for initial setup of wireless cameras)
LNZ4001
LNE3003
Figure 3.1 Wireless connection
PC
LAPTOP
PC
11