Http Events - Lorex LN Series Instruction Manual

Events
NOTE: Check the FTP box to send the snapshot image to an FTP server. Enter the filename prefix in the
text field. Your FTP server needs to be setup separately. Enter the FTP server login information in
>
Settings Network Services
on page 77.

HTTP Events

Use the HTTP Event menu to configure HTTP Events on your networked camera. With HTTP
Events enabled, your Internet camera can be triggered by motion or a triggered 12V alarm from
another camera. The camera can trigger an HTTP server, a 12 volt alarm sensor, or another
camera for a pre-configured action. For more details, see "Appendix I: Setting Up HTTP Events"
on page 110.
Figure 18.1 HTTP Event menu
To enable HTTP Events:
1. Under General HTTP Event, select Enable HTTP event.
2. Under URL, enter the IP address/DDNS domain of the target camera or network device
followed by /cgi-bin/operator/ptzset. For example, 192.168.0.122:81/cgi-bin/operator/ptzset
3. Enter the Port number, user ID and password of the target camera.
4. OPTIONAL: If using a proxy server, enter the proxy server name, port, user name, and
password in the fields.
5. Under Alarm Sending Event, select Enable Alarm Sending Event.
6. Select Enable Alarm Motion Detection.
7. Enter the following parameter: gotoserverpresetname=[Preset#]. For example,
gotoserverpresetname=Preset1. Make sure you enter the preset name EXACTLY as it appears
in the Preset list (Settings
8. Select Enable Alarm input.
9. Enter the following parameter: gotoserverpresetname=[Preset#]. For example,
gotoserverpresetname=Preset2.
10. Click Submit HTTP Event to save your settings.
62
>
Network Recorder Server
>
Preset).
. For details, see "Network Recorder Server"