Supported Protocol Configuration; Users - Tripp Lite B092-016 Owner's Manual

14.5.2

Supported Protocol Configuration

To ensure remote access to serial port 5 is configured as follows:
Telnet Access LAN
SSH Access LAN
Raw TCP via LAN
You would need to issue the following commands from the command line to set system
configuration:
# /bin/config –-set=config.ports.port5.ssh=on
# /bin/config –-del=config.ports.port5.Telnet
# /bin/config –-del=config.ports.port5.tcp
The following command will synchronize the live system with the new configuration:
# /bin/config –-run=serialconfig
Note: "/bin/config" commands can be combined into one command for convenience.
14.5.3

Users

You can add a User to the system from the command line by performing the following
instructions:
Determine the total number of existing Users. If you have no existing Users, you can assume
this is 0.
# /bin/config –-get=config.users.total
This command should display:
config.users.total 1
Note that if you see:
config.users.total
This means you have 0 Users configured.
So your new User will be the existing total plus 1, so if the previous command gave you 0, then
you start with user number 1. If you already have 1 user, your new user will be number 2, etc.
Disabled
Enabled
Disabled
176