Tripp Lite B092-016 Owner's Manual page 137

 Check NSCA Enabled, choose an NSCA Encryption Method and enter and confirm an NSCA
Secret. Remember these details as you will need them later on. For NSCA Interval, enter 5.
 Click Apply.
Next, configure the attached Window network host and specify the services you will be checking with
Nagios (HTTP and HTTPS):
 Select Network Hosts from the Serial & Network menu and click Add Host.
 Enter the IP Address/DNS Name of the network server, (e.g.: 192.168.1.10) and enter a
Description, (e.g.: Windows 2003 IIS Server).
 Remove all Permitted Services. This server will be accessible using Terminal Services, so check
TCP, Port 3389 and log level 1 and click Add. It is important to remove and re-add the service to
enable logging.
 Scroll down to Nagios Settings and check Enable Nagios.
 Click New Check and select Check Ping. Click check-host-alive.
 Click New Check and select Check Permitted TCP. Select Port 3389.
 Click New Check and select Check TCP. Select Port 80.
 Click New Check and select Check TCP. Select Port 443.
 Click Apply.
Similarly, configure the serial port to the router to be monitored by Nagios:
 Select Serial Port from the Serial & Network menu.
 Locate the serial port that has the router console port attached and click Edit.
 Ensure the serial port settings under Common Settings are correct and match the attached
router's console port.
 Click Console Server Mode and select Logging Level 1.
 Check Telnet (SSH access is not required, as SDT Connector is used to secure the otherwise
unsecured Telnet connection).
 Scroll down to Nagios Settings and check Enable Nagios.
 Check Port Log and Serial Status.
137