Set Up Sdt Serial Ports On Console Server; Set Up Sdt Connector To Ssh Port Forward Over The Console Server Serial Port - Tripp Lite B092-016 Owner's Manual

C. For earlier version Windows computers, follow the steps in Section B, above. To get to the Make
New Connection button:
For Windows 2000, click Start and select Settings. At the Dial-Up Networking Folder, click

Network and Dial-up Connections and click Make New Connection. Note: you first may need
to set up a connection over the COM port using Connect directly to another computer before
proceeding to Set up an advanced connection
For Windows 98, you double-click My Computer on the Desktop, then open Dial-Up

Networking and double-click

6.10.2 Set Up SDT Serial Ports on Console Server

To set up RDP (and VNC) forwarding on the Console Server's Serial Port that is connected to the
Windows computer COM port:
 Select the Serial & Network: Serial Port menu option and click Edit (for the particular Serial Port
that is connected to the Windows computer COM port).
 On the SDT Settings menu, select SDT Mode (which will enable port forwarding and SSH
tunneling) and enter a Username and User Password.
Note
When you enable SDT, this will override all other Configuration protocols on that port.
Note
If you leave the Username and User Password fields blank, they default to portXX and portXX
where XX is the serial port number. So the default username and password for Secure RDP over
Port 2 is port02
 Ensure the Console Server Common Settings (Baud Rate, Flow Control) are the same as were set
up on the Windows computer COM port and click Apply.
 RDP and VNC forwarding over serial ports is enabled on a Port basis. You can add Users who can
have access to these ports (or reconfigure User profiles) by selecting Serial & Network :User &
Groups menu tag - as described earlier in Chapter 4 Configuring Serial Ports.

6.10.3 Set Up SDT Connector to SSH Port Forward Over the Console Server Serial Port

In the SDT Connector software running on your remote computer, specify the gateway IP address of
your Console Server and a username/password for a user you have setup on the Console Server that has
access to the desired port.
100