Configure Selected Network Hosts For Nagios Monitoring - Tripp Lite B092-016 Owner's Manual

 Select Enable Nagios, specify the name of the device on the upstream server and determine the
check to be run on this port. Serial Status monitors the handshaking lines on the serial port and
Check Port monitors the data logged for the serial port.

10.3.5 Configure Selected Network Hosts for Nagios Monitoring

The individual Network Hosts connected to the Console Server that is to be monitored must also be
configured for Nagios checks:
 Select Serial & Network: Network Port and click Edit on the Network Host to be monitored.
 Select Enable Nagios, specify the name of the device as it will appear on the upstream Nagios
server.
 Click New Check to add a specific check which will be run on this host.
 Select Check Permitted TCP/UDP to monitor a service that you have previously added as a
Permitted Service.
 Select Check TCP/UDP to specify a service port that you wish to monitor, but do not wish to
allow external (SDT Connector) access.
 Select Check TCP to monitor.
142