Network Configuration; Ip Configuration - Tripp Lite B092-016 Owner's Manual
Console server management switch console server with poweralert console server
Hide thumbs
Also See for B092-016:
- Owner's manual (257 pages) ,
- Quick start manual (4 pages) ,
- Specification sheet (3 pages)
Table of Contents
Advertisement
Time Zone
To change the system time zone USA to Eastern Standard Time, you need to issue the following
commands:
# /bin/config –-set=config.system.timezone=US/Eastern
The following command will synchronize the live system with the new configuration:
# /bin/config –-run=time
14.4
Network Configuration
14.4.1
IP Configuration
Please note that supported interface modes are 'dhcp' and 'static':
DHCP
To enable a DHCP client on the primary Network interface (eth0) from the Console Server
command line:
# /bin/config --set=config.interfaces.wan.mode=dhcp
The following command will then synchronize the live system with the new configuration:
# /bin/config –-run=ipconfig
Note: "/bin/config" commands can be combined into one command, for convenience.
Please note that supported interface modes are 'dhcp' and 'static'.
Static
To set static configuration on the primary Network interface with the following attributes:
IP Address:
Network Mask:
Default Gateway:
192.168.1.100
255.255.255.0
192.168.1.1
172
Advertisement
Table of Contents
