Installing The Ssh Public/Private Keys (Clustering); Installing Ssh Public Key Authentication (Linux) - Tripp Lite B092-016 Owner's Manual

Enter file in which to save the key (/home/user/.ssh/id_rsa):
/home/user/keys/control_room
Enter passphrase (empty for no passphrase):
Enter same passphrase again:
Your identification has been saved in /home/user/keys/control_room
Your public key has been saved in /home/user/keys/control_room.pub.
The key fingerprint is:
28:aa:29:38:ba:40:f4:11:5e:3f:d4:fa:e5:36:14:d6 user@server
$
You must ensure there is no password associated with the keys. If there is a password, then the
devices will have no way to supply it as runtime.
Full documentation for the ssh-keygen command can be found at:
http://www.openbsd.org/cgi-bin/man.cgi?query=ssh-keygen
15.6.3

Installing the SSH Public/Private Keys (Clustering)

For Console Servers, the keys can be simply uploaded through the web interface on the System:
Administration page. This enables you to upload stored RSA or DSA Public Key pairs to the
Master and apply the Authorized key to the Slave as is described in Chapter 4.6. Once
complete, proceed to Fingerprinting as described below.
15.6.4

Installing SSH Public Key Authentication (Linux)

Alternately, the public key can be installed on the unit remotely from the Linux host with
the scp utility as follows:
196