Removing Rear Wheel - BMW S 1000 RR Rider's Manual

9
124
Tighten screws 2 on left and
right to the specified tightening
torque.
Radial brake caliper to
z
axle mount
38 Nm
Insert the ABS sensor into its
bore and install screw 1.
Remove the adhesive tape
from the wheel rim.
Firmly pull the handbrake lever
until the pressure point is per-
ceptible, and repeat this opera-
tion several times.

Removing rear wheel

Place the motorcycle on an
auxiliary stand; BMW Motorrad
recommends the BMW Motor-
rad rear-wheel stand.
Install the auxiliary stand at rear
wheel ( 129).
Slip wooden chocks or similar
under the rear wheel to prevent
it from dropping out after the
quick-release axle has been
removed.
Remove axle nut 1 with
washer.
Slacken locknuts 3 on left and
right.
Slacken adjusting screws 2 on
left and right.
Remove adjusting plate 4 and
push the axle in as far as it will
go.