Open cap 1 of the expansion
tank.
Top up coolant to specified
level.
Checking coolant level
(
114).
Close the cap of the expansion
tank.
Install the side panel (
Body panels
Removing side panel
The procedure described
here for the right side apply
applies by analogy to the left side
panel.
Remove screws 1 and remove
slipstream deflector 2.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
116).
Remove screw 1 on the in-
board side of the side panel.
Remove screws 2.
Remove screws 3 with the
washers.
9
115
z