Abs Fault; Abs Deactivated - BMW S 1000 RR Rider's Manual

Installing number-plate carrier
( 92).
SETUP
In mode, switch on
suppression of the error mes-
sage.
Motorcycle dropped
! VDS
(Vertical Down Sensor)
appears on the blank display.
Possible cause:
The drop sensor has detected a
drop and has cut out the engine.
Bring the motorcycle to the
upright position
Switch the ignition off and
then on again or switch the kill
switch on and then off again.
Drop sensor defective
! VDS
(Vertical Down Sensor)
appears on the display.
Possible cause:
A defect in the drop sensor has
been detected.
Seek the advice of a specialist
workshop, preferably an author-
ised BMW Motorrad dealer.
ABS self-diagnosis not
completed
ABS warning light flashes.
Possible cause:
The ABS function is not
available, because self-
diagnosis did not complete. The
motorcycle has to move forward
a few metres for the wheel
sensors to be tested.
Pull away slowly. Bear in mind
that the ABS function is not
available until self-diagnosis has
completed.

ABS deactivated

ABS warning light shows.
Possible cause:
The rider has switched off the
ABS system.
Activating ABS function
( 42).

ABS fault

ABS warning light shows.
Possible cause:
The ABS control unit has detec-
ted a fault. The ABS function is
not available.
You can continue to ride the
motorcycle, but make due pro-
vision for the fact that the ABS
function is not available. Bear
in mind the more detailed in-
formation on situations that can
lead to an ABS fault (
Have the fault rectified as
quickly as possible by a
specialist workshop, preferably
an authorised BMW Motorrad
dealer.
3
29
z
102).