Bulbs - BMW S 1000 RR Rider's Manual

9
130
Install adapter pins (83 30 2
152 841) 1 in the rear wheel
swinging arm on left and right
and tighten to the specified
z
torque.
Adapter to rear wheel
swinging arm
20 Nm
Turn brackets 2 long ends out.
Adjust adapters 3 to the width
of the pins inserted in the rear
wheel swinging arm.
Set the height of the auxiliary
stand to raise the rear wheel
slightly clear of the ground.
Engage the auxiliary stand in
the rear wheel swinging arm
and apply even pressure to
push it down to the ground.

Bulbs

Replacing low-beam and
high-beam headlight bulb
The plug arrangement can
differ from the illustration,
depending on the bulb to be
replaced.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.