BMW S 1000 RR Rider's Manual page 46

4
44
With the coding plug inserted,
the menu includes
as an additional selectable riding
z
mode.
Installing coding plug (
Repeatedly press button 1 until
SLICK
4 the arrow is to the left of the
setting you want.
45).
sumption on which the parameter
settings are based is that tyre-
to-surface grip is of the very high
level generally encountered only
on race tracks.
Activate SLICK mode only on
race tracks and only when run-
ning the motorcycle on racing
slicks.
When SLICK mode is selected:
Note that ABS control for the
The SLICK mode is set up
for racing slicks and the as-
rear wheel is restricted (see the
section entitled "Engineering
details").
With the motorcycle at a stand-
still, the mode you select is ac-
tivated after approximately ten
seconds.
The newly selected riding
mode is activated as you
ride only when the following
preconditions are satisfied:
Brake not applied
Throttle twistgrip in fully closed
position
Clutch pulled
Once the new ride mode has
been activated, the selection
menu disappears from the dis-
play.
The mode selected in this way
is retained with the engine-
characteristic, ABS and DTC
adaptation settings even after
the ignition has been switched
off.