Removing Rear Wheel - BMW G 310 R Rider's Manual

8
80
Tighten clamping bolts 1 to the
specified tightening torque.
z
Clamping screws in axle
holder
Tightening sequence: Tighten
screws six times in alternate
sequence
19 Nm
Removing the front-wheel
stand.
Remove the adhesive tape
from the wheel rim.
WARNING
Brake pads not lying against
the brake disc
Risk of accident due to delayed
braking effect.
Before driving, check that the
brakes respond without delay.
Operate the brake several
times until the brake pads are
bedded.

Removing rear wheel

OA
with centre stand
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
without centre stand
Lift the motorcycle, preferably
with a BMW Motorrad rear-
wheel stand.
Install the rear-wheel stand
( 66).
Slip wooden chocks or similar
under the rear wheel to prevent
it from dropping out after the
OA