Safety Notice; Fcc Warning; The Fcc Wants You To Know - Emblaze-VCON HD3000 User Manual

Safety Notice

Do not open the HD3000 unit. There are no user-servicable parts inside.
Opening the unit voids the warranty and can also cause injury. Please
refer servicing to Emblaze VCON-trained service personnel.
When you use the HD3000 system, observe the following safety guidelines:
1. Make sure the monitor and attached accessories are electrically rated to operate
with the AC power available in your location.
2. Plug the accessories' power cables into properly grounded power sources.
3. Do not use adapter plugs or remove the grounding prong from a cable. If you
must use an extension, use a three-wire cable with properly grounded plugs.
4. Make sure that nothing rests on the cables and that the cables are not located
where they can be stepped on or tripped over.
5. Do not spill food or liquids on the system or accessories.
6. Keep the system away from radiators and heat sources, and do not block
cooling vents.
7. Do not run the equipment in an environment with ambient temperature higher
than 35°C or lower than 10°C.

FCC Warning

Modifications not expressly approved by the manufacturer could void the user
authority to operate the equipment under FCC rules.

The FCC Wants You to Know

This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at his
own expense.
iv Emblaze VCON HD3000 User's Guide