Table of Contents
Advertisement
Appendix B Software Upgrade
B.4
Installer Mode
If for some reason the upgrade was not successfully completed, HD3000 enters
Installer Mode after it restarts.
1.
Verify that you've entered the correct Network information before running
the upgrade program again.
2.
Write down or copy the IP address of the HD3000. Press <OK>.
3.
Rerun the upgrade process from the HD Upgrade Utility. Be sure to enter
the correct IP address for the HD3000.
If this process is unsuccessful again, contact Emblaze VCON's Technical
Support (see
162
"Emblaze VCON Technical Support" on page
Emblaze VCON HD3000 User's Guide
OK
viii).
Advertisement
Table of Contents
Need help?
Do you have a question about the HD3000 and is the answer not in the manual?