Installing The Ap In A Plenum - Proxim ORiNOCO AP-700 User Giude

Installation and Initialization
Hardware Installation
Mounting the AP-700 to a Ceiling
1. Attach the mounting plate to the bottom of the AP-700 by lining up the keyholes and attaching it with two screws.
2. Snap the tabs onto the ceiling T-bar. Rotate the AP-700 until it snaps on to the T-bar.
Figure 2-5 AP-700 Mounting Plate
Mounting the AP-700 to a Wall
1. Put the mounting plate up to the wall.
2. Screw through the mounting plate.
3. Place the AP up against the mounting plate. Orient the AP with the long access vertical, with the connectors facing to
the left.

Installing the AP in a Plenum

In an office building, plenum is the space between the structural ceiling and the tile ceiling that is provided to help air
circulate. Many companies also use the plenum to house communication equipment and cables. These products and
cables must comply with certain safety requirements, such as Underwriter Labs (UL) Standard 2043: "Standard for Fire
Test for Heat and Visible Smoke Release for Discrete Products and Their Accessories Installed in Air-Handling Spaces".
The AP-700 has been certified under UL Standard 2043 and can be installed in the plenum.
When installed in a plenum, the AP must use Active Ethernet.
AP-700 User Guide
22