Proxim ORiNOCO AP-700 User Giude page 164

Command Line Interface (CLI)
Other Network Settings
• Set Ethernet Speed and Transmission Mode
• Set Interface Management Services
• Configure Wireless Distribution System
• Configure MAC Access Control
• Set RADIUS Parameters
• Set Rogue Scan Parameters
• Set Hardware Configuration Reset Parameters
• Set VLAN/SSID Parameters
• Set Security Profile Parameters
NOTE: See Advanced Configuration
Configure the AP as a DHCP Server
NOTE: You must have at least one entry in the DHCP Server IP Address Pool Table before you can set the DHCP
Server Status to Enable.
[Device-Name]>set dhcpstatus disable
[Device-Name]>set dhcpippooltbl 0 startipaddr <start ip address>
endipaddr <end ip address>
[Device-Name]>set dhcpgw <gateway ip address>
[Device-Name]>set dhcppridnsipaddr <primary dns ip address>
[Device-Name]>set dhcpsecdnsipaddr <secondary dns ip address>
[Device-Name]>set dhcpstatus enable
[Device-Name]>reboot 0
CAUTION: Before enabling this feature, confirm that the IP address pools you have configured are valid addresses on
the network and do not overlap the addresses assigned by any other DHCP server on the network. Enabling
this feature with incorrect address pools will cause problems on your network.
Configure the DNS Client
[Device-Name]>set dnsstatus enable
[Device-Name]>set dnsprisvripaddr <IP address of primary DNS server>
[Device-Name]>set dnssecsvripaddr <IP address of secondary DNS server>
[Device-Name]>set dnsdomainname <default domain name>
[Device-Name]>show dns
Figure A-14 Results of "show dns" CLI command
Configure DHCP Relay
Perform the following command to enable or disable DHCP Relay Agent Status.
NOTE: You must have at least one entry in the DHCP Relay Server Table before you can set the DHCP Relay Status to
Enable.
[Device-Name]>set dhcprelaystatus enable
for more information on these settings.
AP-700 User Guide
164