Proxim ORiNOCO AP-700 User Giude page 174

Command Line Interface (CLI)
Parameter Tables
– TFTP Server Parameters
– IP Access Table Parameters
– Auto Configuration Parameters
configured by downloading a configuration file from a TFTP server during boot up.
• Filtering Parameters
– Ethernet Protocol Filtering Parameters
– Static MAC Address Filter Table
– Proxy ARP Parameters
– IP ARP Filtering Parameters
– Broadcast Filtering Table
– TCP/UDP Port Filtering
• Alarms Parameters
– SNMP Table Host Table Parameters
– Syslog Parameters
• Bridge Parameters
– Spanning Tree Parameters
– Storm Threshold Parameters
– Intra BSS Subscriber Blocking
– Packet Forwarding Parameters
• RADIUS Parameters
– Set RADIUS Parameters
• Security Parameters
– MAC Access Control Parameters
– Rogue Scan Configuration Table
– 802.1x Parameters
– Hardware Configuration Reset
reset password.
– Other Parameters
encryption and authentication mechanisms.
• VLAN/SSID Parameters
• Other Parameters
– IAPP Parameters
– Wireless Multimedia Enhancements (WME)/Quality of Service (QoS) parameters
Multimedia Enhancement/Quality of Service parameters, QoS policies, mapping priorities, and EDCA parameters.
Apply a configured QoS policy to a particular SSID.
- Set up for file transfers; specify IP Address, file name, and file type
- Configure range of IP addresses that can access the AP
- Configure the Auto Configuration feature which allows an AP to be automatically
- Control network traffic based on protocol type
- Enable and disable specific addresses
- Enable or disable proxy ARP for wireless clients
- Control which ARP messages are sent to wireless clients based on IP settings
- Control the type of broadcast packets forwarded to the wireless network
- Filter IP packets based on TCP/UDP port
- Enter the list of IP addresses that will receive alarms from the AP
- Configure the AP to send Syslog information to network servers
- Used to help prevent network loops
- Set threshold for number of broadcast packets
- Enable or disable peer to peer traffic on the same AP
- Redirect traffic from wireless clients to a specified MAC address
- Configure RADIUS Servers and assign them to VLANs.
- Access Point security settings
- Control wireless access based on MAC address
- Enable and configure Rogue Scan to detect Rogue APs and clients.
- Configure 802.1X Supplicant Timeout parameter
- Disable or enable hardware configuration reset and configure a configuration
- Configure Security Profiles that define allowed security modes (wireless clients), and
- Enable the configuration of multiple subnetworks based on VLAN ID and SSID.
- Enable or disable the Inter-Access Point Protocol
AP-700 User Guide
- Enable and configure Wireless
174