Proxim ORiNOCO AP-700 User Giude page 27

Installation and Initialization
Initialization
Figure 2-10 Setup Wizard
Setup Wizard Instructions
1. Click Setup Wizard to begin. If you do not wish to use the Setup Wizard, click Exit. The Setup Wizard supports the
following navigation options:
• Save & Next Button: Each Setup Wizard screen has a Save & Next button. Click this button to submit any
changes you made to the unit's parameters and continue to the next page. The instructions below describe how to
navigate the Setup Wizard using the Save & Next buttons.
• Navigation Panel: The Setup Wizard provides a navigation panel on the left-hand side of the screen. Click the
link that corresponds to the parameters you want to configure to be taken to that particular configuration screen.
Note that clicking a link in the navigation panel will not submit any changes you made to the unit's configuration on
the current page.
• Exit: To exit from the Setup Wizard at any time, click Step 1: Introduction on the navigation panel, and then click
the Exit button.
CAUTION: If you exit from the Setup Wizard, any changes you submitted (by clicking the Save & Next button) up
to that point will be saved to the unit but will not take effect until it is rebooted.
2. Configure the System Configuration settings and click Save & Next. See
NOTE: On APs with model numbers ending in -WD, -EU, or -UK you must select the operating country on this page or
on the Configure > System tab. Setting the country makes the AP automatically compliant with the rules of
the regulatory domain in which it is used by configuring the allowed frequency bands, channels, Dynamic
Frequency Selection status, Transmit Power Control status, and power levels. If the country is not selected, an
informational message will appear on the Status page, and you will be unable to configure interface
parameters.
3. Configure the Access Point's IP Configuration, including basic IP address settings, if necessary, and click Save &
Next. See Basic IP Parameters
4. On the Password Configuration screen, assign the AP new passwords to prevent unauthorized access and click
Save & Next. Each management interface has its own password:
• SNMP Read Password
• SNMP Read-Write Password
• CLI Password
• HTTP (Web) Password
By default, each of these passwords is set to "public". See
for more information.
System
Passwords for more information.
AP-700 User Guide
for more information.
27