Proxim ORiNOCO AP-700 User Giude page 117

Advanced Configuration
SSID/VLAN/Security
• Enable: The SSID is not advertised in the beacon, and the AP will respond to probe requests with an SSID only if
the client has specified the SSID in the probe request. If the client sends a probe request with a null or "ANY"
SSID, the AP will respond not respond.
• Partial: The SSID is advertised in the beacon, and the AP will not respond to "ANY" SSID requests. The Partial
setting reduces network traffic by eliminating the repeated broadcast of SSIDs in probe responses.
• Disable: The SSID is advertised in the beacon, and the AP will respond with each configured SSID, whether or
not an SSID has been specified in the probe request.
7. Enable Broadcast SSID by checking the selection box. Broadcast SSID allows the broadcast of a up to four unique
beacons when the AP is configured for multiple SSIDs. If you have more than four SSIDs configured, then three
SSIDs will be broadcast in individual beacons; the fourth and subsequent SSIDs will be combined and broadcast in
one beacon.
NOTE: Enabling Broadcast SSID will lower the throughput of the AP by 2-4%.
NOTE: Enabling Broadcast SSID simultaneously with Rogue Scan will cause a drift in the beacon interval and the
occasional missing of beacons.
8. Enable or disable the SSID Authorization status from the drop-down menu. SSID Authorization is the RADIUS-based
authorization of the SSID for a particular client. The authorized SSIDs are sent as the tunnel attributes.
9. Enable or disable RADIUS accounting on the VLAN/SSID under the Accounting Status drop-down menu.
10.Enable or disable RADIUS MAC authentication status on the VLAN/SSID under the RADIUS Authentication Status
drop-down menu.
11. Enable or disable MAC Access Control List status on the VLAN/SSID under the MAC ACL Status drop-down menu.
12.Enter the Rekeying Interval in seconds (between 300 and 65525). When set to 0, this parameter is disabled. The
default is 900 seconds.
13.Enter the Security Profile used by the VLAN in the Security Profile field.
NOTE: If you have two or more SSIDs per interface using a Security Profile with a security mode of Non Secure, be
aware that security being applied in the VLAN is not being applied in the wireless network.
14.Define the RADIUS Server Profile Configuration for the VLAN/SSID:
• RADIUS MAC Authentication Profile
• RADIUS EAP Authentication Profile
• RADIUS Accounting Profile
If 802.1x, WPA, or 802.11i security mode is used, the RADIUS EAP Authentication Profile must have a value.
A RADIUS Server Profile for authentication for each VLAN shall be configured as part of the configuration options for
that VLAN. RADIUS profiles are independent of VLANs. The user can define any profile to be the default and
associate all VLANs to that profile. Four profiles are created by default, "MAC Authentication", "EAP Authentication",
Accounting", and "Management".
15.Specify a QoS Profile. See the
16.Set the 802.1p Priority given to packets tagged with this VLAN ID. Enter a number between 0-7.
17.If editing an entry, enable or disable the parameters on this page using Status drop-down menu. If adding a new entry,
this drop-down menu will not appear.
18.Reboot the AP.
Policy section for more information.
AP-700 User Guide
117