Network Parameters - Proxim ORiNOCO AP-700 User Giude

Command Line Interface (CLI)
Parameter Tables
Country
Spain
South Korea
Sweden
Switzerland
Taiwan
United Arab Emirates Indoor
United Kingdom
Inventory Management Information
The inventory management commands display advanced information about the AP's installed components. You may be
asked to report this information to a representative if you contact customer support.
Name
System Inventory
Management
Component Table
Component Interface
Table

Network Parameters

IP Configuration Parameters
Name
Network
IP Configuration
IP Address
IP Mask
Default Router IP
Address
Default TTL
Address Type
NOTE: The IP Address Assignment Type (ipaddrtype) must be set to static before the IP Address (ipaddr), IP Mask
(ipmask) or Default Gateway IP Address (ipgw) values can be entered.
Indoor/Outdoor
Indoor ES1
Outdoor ES2
Indoor/outdoor KR1
Indoor SE1
Outdoor SE2
Indoor CH1
Outdoor CH2
Indoor TW1
Outdoor TW2
AE1
Indoor GB1
Outdoor GB2
Type
Subgroup
Subgroup
Subgroup
Type
Group
Group
IpAddress
IpAddress
IpAddress
Integer
Integer
Identifier
Value
N/A
N/A
N/A
Value
N/A
N/A
User Defined
User Defined
User Defined
User Defined (seconds)
0 - 255, 64 (default)
static
dynamic (default)
AP-700 User Guide
Access CLI Parameter
R sysinvmgmt
R sysinvmgmtcmptbl
R sysinvmgmtcmpiftbl
Access CLI Parameter
R network
R ip (Note: The network and
ip parameters display the
same information)
RW ipaddr
RW ipmask
RW ipgw
RW ipttl
RW ipaddrtype
178