F Professional Installation; Installing External Antennas - Proxim ORiNOCO AP-700 User Giude

Professional Installation
All products using external antennas must be professionally installed, and the transmit power of the system must be
adjusted by the professional installers to ensure that the system EIRP is in compliance with the limit specified by the
regulatory authority of the country of application.
See the following sections for more information:
•

Installing External Antennas

• Adjusting Tx Output Power
• Antenna Types and Maximum Gain
NOTE: See Hardware Installation
Installing External Antennas
Only a professional installer can install external antennas on the AP-700. For information on the AP's antenna
functionality, see Antennas.
Follow the mounting instructions included with your external antenna, and then connect the antenna cable to the AP, as
follows:
1. Press down near the center of the compartment covering and slide open the external antenna access compartment.
The compartment closer to the LED panel contains the connectors.
NOTE: AP-700 models 8675-US2 and 8675-AU do not provide external antenna connectors.
Figure F-1 Opening the Antenna Compartment
2. There are two antenna connectors in the AP-700, labeled 1 and 2. Connect the antenna cable to connector 1 (the
connector closer to the LED panel in the compartment).
for cabling and mounting instructions.
AP-700 User Guide
F
220