Konica Minolta bizhub pro 950 User Manual page 252

12
See example below.
Data Requested
Printer Name
Remote System Name
Remote printer Name
Setting Up an AS/400 System to Use lpd
When working with the output queue description (WORKOUTQD), there are several fields that must be
defined for the network interface card to function properly as a remote printer device.
Use the following procedure to define fields for the network interface card to make it function as a remote
printer:
1
When prompted for the remote system, type INTNETADR so the AS/400 recognizes the device as an
IP device
2
Port must be [PRINT].
3
Connection type must be [IP].
4
Internet address must be the IP address of the network interface card.
5
Destination type must be [OTHER].
6
When prompted for transforming SCS to ASCII, type YES to allow the AS/400 do the character
translation.
7
Manufacturer type and model must be the print driver that goes with your image controller.
Setting Up a SCO UNIX Remote Printer to Use lpd
Use the following procedure to set up a remote printer on the host that sends jobs to the network interface
card using lpd.
1
At the prompt, enter the mkdev rlp command.
– You cannot run mkdev rlp twice. If you have additional printers to be configured, use the rlpconf
command.
2
You are now asked a series of questions. Respond as follows (shown in bold type):
– Please enter a printer name: lprprinter1
– Is lprprinter1 a remote printer or a local printer? R
– Enter remote host name: lprprinter
– Confirm the information you entered: Y
– Confirm the preceding connection as your system
– default: Y
– Enter another printer name or quit setup: Q
3
If necessary, stop and restart your remote daemon.
4
Using a line editor of your choice, edit the /etc/printcap file and change the:
rp=entry to PRINT.
12-28
Example
myprinter
fastprint
PRINT
Utility Tool
Description of Input Data
name to be used in lp command
Network Interface Card hostname as
in /etc/hosts
lpd queue name
bizhub PRO 950 (Version 2)