Konica Minolta bizhub pro 950 User Manual page 177

PostScript PPD printer driver setting (Windows)
Tandem Mode
Using two printing systems (master copier and sub copier), prints can be made at the same time under the
same printing conditions. When printing a large number of copies, time required to complete the job can be
shortened.
When either one of the two copiers is equipped with a image controller, tandem printing can be performed.
When both of the copiers are equipped with a image controller, the copier which receives the printing job
instruction functions as the master copier and the other one is the sub copier.
For the tandem printing, the two copiers should be connected by either method as follows.
- Connect the two copiers directly with a cross cable. In this case, the network functions cannot be used.
- Connect them with a straight cable via HUB.
Note
Use a cross cable or straight cable higher than the category type 5.
Tandem printing should only be set up by your authorized service representative.
Refer to the "User's Guide (POD Administrator's Reference)" for more information about Tandem Mode.
Tandem Mode cannot be set in the following cases:
- When [Transparency Interleave] is selected.
bizhub PRO 950 (Version 2)
Master copier
Sub copier
8
8-29