Table of Contents
Advertisement
3.2.1.1
Change Adapter Status
3.2.1.2
Adapter Boot Order
Change Adapter Status allows you to activate or deactivate a host
adapter and all SCSI devices attached to it. When this option is used to
make a change, the change takes place after a reboot upon exit from the
utility.
Figure 3.2
is an example of the Change Status on Next Boot Menu.
Figure 3.2
Change Status on Next Boot Menu
Main Menu
Change Status on Next Boot:
Port
Num
LSI53C875
FC00
LSI53C875
F800
LSI53C895
F801
To change an adapter's status, select it and press Enter. Press the
Escape (Esc) key to exit from this menu.
Adapter Boot Order allows the user to set the order in which host
adapters will boot when you have more than one LSI Logic host adapter
in your system. When this option is selected, the Boot Order menu
appears.
Figure 3.3
Figure 3.3
Boot Order Menu
Main Menu
BootSeq
Bus DevFunc BootSeq
0
LSI53C875 00
2
LSI53C895 00
To change an adapter's boot order, select it and press Enter. You are
then prompted to enter the new boot sequence number. To remove an
adapter's boot order, press Enter again rather than entering a new
sequence number. While the maximum capacity is 32 adapters, only four
Starting the SCSI BIOS Configuration Utility
Irq---------Status--------NVRAM
Level Current
9
On
9
On
9
On
is an example of the Boot Order menu.
A0
1
90
Next-Boot Found
On
Yes
Off
Yes
Off
Yes
Bus DevFunc
LSI53C875 00
98
3-5
Advertisement
Table of Contents
