Starting The Scsi Bios Configuration Utility; Device Default Settings - LSI LSIU40SE User Manual

3.2 Starting the SCSI BIOS Configuration Utility
3-2
Table 3.2

Device Default Settings

Settings for Individual SCSI Devices
Synchronous Transfer Rate (Mbytes/s)
Data Width
Disconnect
Read/Write I/O Time-out (seconds)
Scan for Devices at Boot Time
1
Scan for SCSI LUNs
Queue Tags
1. Logical Unit Number.
If you have LSI Logic SCSI BIOS Version 4.xx, and it includes the
LSI Logic SCSI BIOS Configuration Utility, you can change the default
configuration of the SCSI host adapters. You may decide to alter these
default values if there is a conflict between device settings or if you need
to optimize system performance.
You can see the version number of your SCSI BIOS in a banner
displayed on your computer monitor during boot. If the utility is available,
the following message also appears on your monitor:
Press Ctrl-C to start LSI Logic Configuration Utility...
This message remains on your screen for about five seconds, giving you
time to start the utility. If you decide to press "Ctrl-C," the message
changes to:
Please wait, invoking LSI Logic Configuration Utility...
After a brief pause, your computer monitor displays the Main Menu of the
LSI Logic SCSI BIOS Configuration Utility.
NVRAM is available on the LSIU40SE. Changes can be made and stored
to NVRAM using this menu driven utility.
Configuring the LSIU40SE
Default Settings
40
16
On
10
Yes
Yes
On