LSI LSIU40SE User Manual page 18

2-2
Step 4. Locate the slots for PCI plug-in board installation. The
LSIU40SE requires a PCI slot that allows bus master operation.
Step 5. Remove the blank bracket panel on the back of the computer
aligned with the PCI slot you intend to use. Save the bracket
screw.
Step 6. Carefully insert edge connector J1 (see
adapter into the PCI slot. Make sure the edge connector is
properly aligned before pressing the board into place.
Note: You may notice that the components on a PCI host adapter
face the opposite way from non-PCI adapter boards you
have in your system. This is correct, and the board is keyed
to go in only one way.
Step 7. The bracket around the connectors J3 and J7 (see
should fit where the blank bracket panel was removed. Secure
the bracket with the bracket screw before making the internal
and external SCSI bus connections.
Step 8. If you are connecting any internal SCSI devices, plug a 68-pin
connector on the end of the internal SCSI ribbon cable into
connector J2 or J6 for Wide SCSI, or a 50-pin connector into
connector J4 or J8 for normal SCSI (see
certain to match pin 1 on both connectors.
Step 9. Connect your computer's LED cable if desired. This is designed
to drive the front panel LED found on most PC cabinets to
indicate activity on the SCSI bus.
Step 10. Replace the cabinet cover as described in the user's manual for
your computer.
Step 11. Make all external SCSI bus connections. Finally, refer to the
PCI Storage Device Management System SDMS 4.0 User's
Guide (or the guide for the software that you will use) to load
the driver software for your particular operating system.
Remember: The SCSI bus requires proper termination, and no
duplicate SCSI IDs.
Installing the LSIU40SE
Figure 2.1) of the host
Figure 2.1)
Figure 2.1). Make