2.2.11 Setting Scsi Ids - LSI LSIU40SE User Manual

2.2.11 Setting SCSI IDs

2-26
You must set each SCSI device and the host adapter to a separate SCSI
ID 0 through 15. SCSI ID 7 is the preset host adapter setting, giving it
the highest priority on the SCSI bus. If you plan to boot your computer
from a SCSI hard disk drive on the SCSI bus, that drive should have
SCSI ID 0, or the lowest SCSI ID on the bus.
LSIU40SE," explains how to set your host adapter ID using the LSI Logic
SCSI BIOS Configuration Utility.
The peripheral device SCSI IDs are usually set with jumpers or with a
switch on the peripheral. Refer to the peripheral manufacturer's
instructions and to the user's manual for your computer to determine the
ID of each device and how to change it. You must have no duplication of
SCSI IDs on a SCSI bus.
Step 1. Determine the SCSI ID of each device on the SCSI bus. Note
any duplications and if 8-bit SCSI devices are to be used, the
host adapter ID must not be set above 7.
Step 2. Make any necessary changes to the SCSI IDs and record the
IDs for future reference.
keep this record.
Installing the LSIU40SE
Chapter 3, "Configuring the
Table 2.1 is provided as a place to