Table of Contents
Advertisement
Step 6. Most PC cabinets are designed with a front panel LED
(sometimes already connected to an existing IDE drive). You
may connect this LED cable to the host adapter, as shown in
Figure
2.10. This causes the front panel LED to indicate activity
on the SCSI bus.
This connector is not keyed. The orientation of the LED cable
does not matter as long as all four pins are connected.
Figure 2.10 SCSI LED Connectors
Some LED cables have only two wires. In this case, place the connector
on one end or the other of J5 or J9. If the LED does not light during SCSI
bus activity from this host adapter, you may have to rotate the LED cable
180° on J5 or J9.
Detailed Installation Procedure
2-15
Advertisement
Table of Contents
