Creating Pppoe Profiles - Cisco ASR 9000 Series Configuration Manual

Provisioning PPP PTA Session

Creating PPPoE Profiles

Perform this task to create PPPoE profiles. The PPPoE profile will later be applied to an access interface.
SUMMARY STEPS
1. configure
2. pppoe bba-group bba-group name
3. service name service_name
4. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 pppoe bba-group bba-group name
Example:
RP/0/RSP0/CPU0:router(config)# pppoe bba-group
bba_1
Step 3 service name service_name
Example:
RP/0/RSP0/CPU0:router(config-bbagroup)# service
name service_1
Step 4 Use the commit or end command.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide,
Release 4.2.x
68
Purpose
Enters global configuration mode.
Creates a PPPoE profile with an user-specified name.
Indicates the service that is requested by the subscriber.
Repeat this step for each service name that you want to add to
the subscriber profile.
commit—Saves the configuration changes and remains within
the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Establishing Subscriber Sessions
OL-26148-02