Configuring Automated Testing; Cisco Asr 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide - Cisco ASR 9000 Series Configuration Manual

Configuring Automated Testing

configure
radius-server ipv4 dscp 43
radius-server ipv4 dscp default
!
end
Configuring Automated Testing
Perform this task to test if the external RADIUS server is UP or not.
SUMMARY STEPS
1. configure
2. radius-server idle-time idle_time
3. radius-server test username username
4. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 radius-server idle-time idle_time
Example:
RP/0/RSP0/CPU0:router(config-radius-host)# radius-server
idle-time 45
Step 3
radius-server test username username
Example:
RP/0/RSP0/CPU0:router(config-radius-host)# radius-server
test username user1
Step 4
Use the commit or end command.

Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide,

Release 4.2.x
30
Configuring Authentication, Authorization, and Accounting Functions
Purpose
Enters global configuration mode.
Specifies the idle-time after which the automated test
should start. The idle time is specified in minutes, and
ranges from 1 to 60.
Specifies the username to be tested for the automated
testing functionality.
commit—Saves the configuration changes and
remains within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits
the configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
OL-26148-02