Cisco ASR 9000 Series Configuration Manual page 136

Configuring Policy on S-VLAN
• S-VLAN policy has to be provisioned before any policies are installed on subscribers.
Note
• Application of S-VLAN policy is rejected, if policies are already installed on subscribers.
• Removal of S-VLAN policy is rejected, if subscriber policies are present under that S-VLAN.
SUMMARY STEPS
1. configure
2. interface type
3. service-policy output name subscriber-parent
4. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 interface type
Example:
RP/0/RSP0/CPU0:router(config)# interface
Bundle-Ether1.1
Step 3 service-policy output name subscriber-parent
Example:
RP/0/RSP0/CPU0:router(config-if)#
service-policy output svlan
subscriber-parent
Step 4 Use the commit or end command.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide,
Release 4.2.x
126
Purpose
Enters global configuration mode.
Configures the subscribers on the Bundle-Ether access interface.
Configures the s-vlan policy with the subscriber-parent keyword.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Deploying the Quality of Service (QoS)
OL-26148-02