▀ Configuring the IPSG
Option 3: RADIUS Snoop Mode Configuration
To create an IPSG context and IPSG service in RADIUS Snoop Mode, use the following configuration:
configure
context <ipsg_context_name>
ipsg-service <ipsg_service_name> mode radius-snoop
bind
connection authorization [ encrypted ] password <password>
radius accounting server <ipv4/ipv6_address>
radius dictionary <dictionary_name>
end
ISP Context Configuration
To configure the ISP context:
Step 1
Create an ISP context as described in the
Step 2
Create an interface within the ISP context to connect to the data network as described in the System Administration
Guide.
Step 3
Create an IP access control list within the ISP context as described in the IP Access Control Lists chapter of the System
Administration Guide.
Creating the ISP Context
To configure an ISP context, use the following configuration. Note that the following configuration also includes an IP
route for data traffic through the IPSG context.
configure
context <isp_context_name>
subscriber default
exit
ip access-list <access_list_name>
redirect css service <css_service_name> any
permit any
exit
aaa group default
▄ Cisco ASR 5000 IP Services Gateway Administration Guide
26
Creating the ISP Context
section.
IP Services Gateway Configuration
OL-27210-02