Activating Vpdn Logging - Cisco ASR 9000 Series Configuration Manual

Provisioning PPP LAC Session
Command or Action
Step 2
vpdn
Example:
RP/0/RSP0/CPU0:router(config)# vpdn
Step 3 session-limit number_of_sessions
Example:
RP/0/RSP0/CPU0:router(config-vpdn)# session-limit
200
Step 4 Use the commit or end command.
Configuring Maximum Simultaneous VPDN Sessions: An example
configure
vpdn
session-limit 200
!
end

Activating VPDN Logging

Perform this task to activate logging of VPDN event information. When VPDN event logging is enabled,
VPDN event messages are logged as the events occur.
Tunnel start and stop records are generated without any tunnel statistics.
Note
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide,
Release 4.2.x
78
Purpose
Enables VPDN and enters the VPDN sub-mode.
Configures the maximum simultaneous VPDN sessions. The
range is from 1 to 131072.
If limit is configured after a number of sessions are
Note
up, then those sessions remain up irrespective of the
limit.
commit—Saves the configuration changes and remains within
the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Establishing Subscriber Sessions
OL-26148-02