Microscan N2210WZ Owner's Manual page 186

I/O Parameters
EZ Button Modes
Useful for performing multiple, repetitive tasks at the work site.
Allows the user to program each of the EZ Button's 4 positions from a selection of 8 modes.
Single Beep
Hold down button until a single beep is heard (and the 20% LED illuminates).
Disabled
When set to Disabled, the associated button position will have no function associated with
it, and the position will be skipped over.
Read Rate
Read Rate is initiated when the associated button position is selected. Read Rate will
perform decodes/second and is the same as sending a
Read Rate, quickly press and release the EZ Button.
Calibration
Calibration is initiated when the associated button position is selected. To cancel Calibration,
quickly press and release the EZ Button.
Save for Power-On
All scanner settings will be saved to non-volatile memory to be recalled on power-on
whenever the associated button position is selected. This is the same as sending a
from ESP's Terminal.
Auto Framing
Auto Framing is initiated when this button position is selected. To cancel Auto Framing,
quickly press and release the EZ Button.
Load New Master
Functions in the same way as
position is selected.
Sleep Mode
When Sleep Mode is selected, the scanner will shut the motor and laser off when this
button position is selected. To cancel Sleep Mode, quickly press and release the EZ Button.
Bar Code Configuration
Enables Bar Code Configuration Mode whenever the associated button position is
selected. When enabled, the scanner can accept configuration commands from symbols.
To disable, quickly press and release the EZ Button.
5-120
New Master Pin input whenever the associated button
QX-870 Industrial Raster Scanner User's Manual
<C> from ESP's Terminal. To exit
<Z>