Microscan N2210WZ Owner's Manual page 185

EZ Button Status
Disabled
When set to Disabled, the EZ Button does not function.
Enabled
When selected, the EZ Button is enabled and the function of each button position is
selected by the EZ Button Modes
Trigger
When selected, the EZ Button acts as a trigger for the scanner to start and end read
cycles. All other button operations are inactive.
In External The read cycle endures for as long as the EZ Button is pressed, unless a
Level: timeout occurs and
In External As with
by pressing the EZ Button, but unlike
Edge:
with a good read output, a timeout, or a new trigger.
Unlatch Outputs
In this configuration, the EZ Button will unlatch any logic outputs that have been latched.
Parameter Switch
The parameter switch toggles between custom defaults and power-on settings. The condition
is the same as that achieved by sending the
Default on Power-On
When enabled, if the EZ Button is held down on power-on, the scanner will default to
customer defaults and save for power-on. This is the same as sending a
from ESP's Terminal.
QX-870 Industrial Raster Scanner User's Manual
command.
End of Read Cycle Mode
External Level, External Edge
<Arc>
Scanner Parameters
is set to Timeout.
allows a read cycle to be initiated
External Level, the read cycle ends
and <Arp> commands consecutively.
<Zrc> command
5-119