Operation
Recording
Recording Video
After installing the DVR (see
change the setup using the Record setup screen (see
DVR immediately begins to record video.
Although you can record without changing the unit from its original factory settings, you
can use the many tools to set the DVR for your recording needs. See
Configuration
Recycling the Hard Disk Drive
The factory default is Recycle On. When the hard disk drive is full, the DVR will record
over the oldest recorded video.
When set to Recycle Off, the DVR stops recording when the hard disk drive is full.
Setting the Resolution
The factory default resolution is Standard (CIF). When set to Standard, the DVR has a
maximum recording speed of 120 ips. When set to High (Half D1),the maximum
recording speed is 60 ips. When set to Very High (D1), the maximum recording speed
is 30 ips.
Panic Recording
To activate Panic recording of all cameras, press
recording.
Document 800-03097 Rev C
03/09
Chapter 2,
for detailed descriptions of the recording mode options.
Note
When the DVR is not in the Recycle mode (see
Hard Disk Drive
been used, panic recording will not operate.
Installation), you are ready to record. Unless you
Configuration
on page 113)and all available storage space has
. Press
on page 33), the
Chapter 3,
Recycling the
again to stop panic
113