Figure 3-56 Motion Detection - Min. Blocks Setup Screen - Honeywell HRSD40F User Manual

3.
Setting the Minimum Number of Motion Detection Blocks
You can adjust the minimum number of detection blocks that must be activated to
trigger a motion alarm. Daytime and Nighttime can be set independently.
Highlight a field under the Min. Blocks heading and press
- Min. Blocks screen appears.
For greater sensitivity, select a smaller number of blocks. A smaller number means that
fewer detection blocks need to be triggered for motion detection.
Viewing How the DVR Reacts to Motion
Zone View allows you to observe how the DVR reacts to motion. When in the motion
viewing mode, any detected motion within the zone displays in red.
Highlight the box beside Zone View, and press
Ignoring Excessive Motion
You can control excessive event logging and remote notification of motions detected
after the motion dwell time by adjusting the motion ignoring dwell intervals.
1.
2.
86
Table 3-11
Option Function
Clear All Deactivates all blocks so they will not detect motion.
OK Accepts changes and closes Zone setup.
Cancel Exits Zone setup without saving changes.
Save your changes by highlighting OK and pressing
the screen without saving the changes.
Figure 3-56
Highlight the box beside Motion Ignoring Interval and press
menu of intervals ranging from 1 to 5 seconds or Never appears.
Select an interval from the drop-down menu.
Motion Detection Zone Setup Screen Options
Motion Detection - Min. Blocks Setup Screen
HRSD40F DVR User Guide
. Select Cancel to exit
. The Motion Detection
to toggle it On and Off.
. A drop-down