State Codes; Figure 19: Examples Of State Codes; Table 5: State Codes - Hughes HN9000 User Manual

Chapter 2
• Addressing – Contains addressing information such as LAN port address and subnet mask and available public IP
addresses (if any, depending on your service plan).
• Software Features – This section lists the optional features and provides information on whether they are currently
active. These features are enabled or disabled per your service plan and cannot be changed locally.

State codes

A state code is a number that indicates the operational state of the satellite modem. Some state codes indicate an error
condition. State codes are identified as State code followed by a number from 1 – 35. They are displayed with an
explanation in words, as shown in the following example.
State codes appear on screens displayed during a hard reboot (when power is removed and then restored) and on System
Control Center pages.
Table 5: State codes on page 20 lists and explains all HN9000 state codes.
In the state code table, modem refers to the satellite modem.

Table 5: State codes

State code State name
1 Starting Up in Boot
2 Waiting for Installation
Parameters
3 Coarse Pointing in
Progress
4 Acquiring Beacon in Boot
5 Acquiring PTP SNR in
Boot
6 Waiting for Uplink
Polarization Change
20
HN9000 Satellite Modem User Guide –
1037577-0001 Rev. A

Figure 19: Examples of state codes

Explanation
Installation – Boot phase
Satellite modem is starting up in boot
phase.
Modem has not been installed, and
installation parameters have not been
submitted.
Antenna pointing is in progress
(coarse or fine pointing). Occurs
during modem installation only.
Occurs during Auto modem
replacement only: Modem is searching
for beacon.
Occurs during Auto modem
replacement only: Modem is searching
for point-to-point signal.
Modem is waiting for installer to
switch uplink polarization at the radio
assembly. Occurs during installation
only.
System Control Center
Corrective action
Transient – No action is necessary.
Transient – No action is necessary.
Transient – No action is necessary.
Transient – No action is necessary.
Transient – No action is necessary.
Installer should switch polarization.