Chapter 6: IP interface configuration
8. To set the control interface, type set control interface ipaddr netmask and
press Enter, where ipaddr is the customer-provided IP address and netmask is the
customer provided subnet mask.
9. Type quit and press Enter to save the changes and exit the IPSI session.
10. Log back in to the IPSI using SSH.
11. Type show control interface and press Enter.
The system displays IP address, subnet mask, and default gateway information.
Verify that the proper information was entered.
12. If a default gateway is used, enter the gateway IP address with
set control gateway gatewayaddr, where gatewayaddr is the customer-provided
IP address for their gateway.
13. Type quit and press Enter to save the changes and exit the IPSI session.
14. Log back in to the IPSI using SSH.
15. Use show control interface to verify the administration.
16. Type exit and press Enter.
Setting the VLAN and diffserv parameters
1. Connect to the IPSI and log in as craft.
2. To display the quality of service values, type show qos and press Enter.
68 Installing and Configuring the Avaya S8500-Series Server