Setting Lan Parameters - Avaya Configuring IP Office R8.0 Application Notes

5.1. Setting LAN Parameters

From the configuration tree in the left pane, select System. Click tab LAN1  LAN Settings to
display the LAN Settings screen in the right pane.

Set the IP Address, which will be the address of the IP Office.

Set the IP Mask based on the network setup.

Set the DHCP Mode based on the network requirement. In this case, the Disabled option
is chosen since DHCP was not used.

Other fields can be left blank or at the default settings.
5.2. Administer SIP Registrar
Select SIP Registrar sub-tab in the right pane and enter the following values:

Domain Name: Enter a valid Domain Name. In this case, it was left blank as registration
is done using the IP address of the LAN1 interface.

Layer 4 Protocol: Select Both TCP & UDP.

TCP Port: Set to 5060 (default).

UDP Port: Set to 5060 (default).
RP; Reviewed:
SPOC 6/25/2012
Solution & Interoperability Test Lab Application Notes
©2012 Avaya Inc. All Rights Reserved.
6 of 19
2NHeliosIP-IPO8