User-Definable Units - Setra Systems Super Count Operator's Manual

It is often convenient to weigh in user-defined units. Conversion factors can be entered through the
keyboard to be multiplied by the displayed weight, or divisors can be entered to be divided into the
displayed weight. The conversion factor will remain in memory even after the scale is powered off.
"x" UNITS
"x" units can be directly changed by entering a factor or divisor. To measure in "x" units, proceed as
follows:
1. Calculate the ratio you wish to enter. If your ratio is in grams per "x" unit, ounces per "x" unit,
pounds per "x" unit, etc., you will enter a divisor. Proceed with Steps 2 through 7.
If your ratio is in "x" units per gram, "x" units per ounce, "x" units per pound, etc., you will enter
a factor. Proceed with Steps 2 through 7, skipping Step 3.
2. Press the units key until the display reads in the known units from which you wish to convert.
3. If you are entering a divisor, press —.
4. Enter the conversion ratio.
5. Press the units key.
6. Place an object on the scale.
7. Wait for the "OK" symbol, then read the display. The reading given is in "x" units.
TM
Setra Super Count Operator's Manual
Appendix I

User-Definable Units

29