Setra Systems Super Count Operator's Manual page 10

NOTE: a. A customized sample size may be preset by using the minimum sample size setup fea-
ture. The scale will never request a sample size less than the preset minimum sample
size. (e.g. If the minimum sample size has been preset at 12 pieces then the sample size
key will display Add 12 PCs, Add 25 PCs, Add 50 PCs, Add 100 PCs, Add 12 PCs...etc.
when pressed repeatedly.)
b. The scale may request that more pieces be added after the initial sampling if a minimum
accuracy requirement has been preset. (For details see the section entitled Using the
Minimum Sample Size or Minimum Accuracy Feature.)
BASIC COUNTING USING THE COUNT KEY
To count a number of like objects on the scale, use the following procedure:
1. Press the zero key.
2. Place a known number of pieces on the pan.
3. Enter the number of pieces through the scale keyboard.
4. Press the count key.
5. Wait for the "OK" symbol.
6. Add pieces until you reach the desired count.
7. Wait for the "OK" symbol, then read the display.
NOTE: The scale may request that more pieces be added after the initial sampling if a minimum
accuracy and/or minimum sample size requirements have been preset.
The operator may choose to employ the counting procedure outlined above which uses the
sample size key, or the procedure given for use of the count key. Both procedures deliver the
same level of accuracy using the same sample size.
10
TM
Setra Super Count Operator's Manual