Setra Systems Super Count Operator's Manual page 21

2. Update the APW and/or tare, either by entering the values through the keyboard, bar code or
by performing the tare and sampling procedures.
3. Press the setup/cal key and then the apw key.
4. The scale will display "ChAngE". To permanenty store these updated values press setup/cal.
The scale will quickly display "StOrEd" and return to the previous weighing or counting mode.
The new values are now stored with the ID in memory.
To exit without changing the existing APW and tare values press the clear key.
If the scale displays "LOcKEd" the stored IDs are protected. The ID protection setup should be set to
"NO LOC" before the APW and/or tare value may be changed.
DELETING AN ID AND APW/TARE VALUES FROM THE DATABASE
To perform the following procedure, the database must be enabled and the APW and tare values
must not be protected. (See section entitled DATABASE SETUP to enable the database and PRO-
TECTING THE APW/TARE VALUES to select a specific protection mode.)
To delete an ID and its associated APW and tare values follow the steps below:
1. Enter the ID and press the id key. The scale will enter the counting mode.
2. Press the setup/cal key then the — and apw keys.
3. The scale will display "dELEtE." Press setup/cal to delete the ID, APW and tare values. The
scale will briefly display "GOnE."
Press clear to exit this procedure without deleting the existing ID, APW and tare values.
If the scale displays "UnAbLE" the stored IDs are protected. The ID protection setup should be set to
"NO LOC" before the APW and/or tare value may be deleted.
COUNT/WEIGHT ACCUMULATOR DATABASE
The Super Count can be programmed to accumulate the weight and count for 256 different, ten
character part numbers. The accumulated count and weight are stored in non-volatile memory until
they are cleared. The count/weight accumulator database feature can only be used if the APW/tare
database is disabled, likewise the APW/tare database can only be used if the count/weight accumu-
lator database is disabled. (To enable this feature, see COUNT/WEIGHT ACCUMULATE BY ID SETUP
in Appendix II.)
TM
Setra Super Count Operator's Manual 21