Setra Systems Super Count Operator's Manual page 27

To program the script as the default label design, enter 0. This will program the scale to print
this label design each time the print key is pressed. To print scripts with identifying numbers 1-
9, the corresponding number needs to be entered followed by the print key on the scale's
keypad (ex. 3 print).
CAUTION: An existing script will be erased from memory when its identifying number is reentered.
4. The display will read "CodES". Enter each code's number followed by the setup/cal key. (Ex.
65 setup/cal for the capital letter A. Refer to the Appendix XI for specific code listings.) "CodES"
will reappear on the display after each code is entered.
NOTE: To clear an incorrect number from the display, press the clear key. Then enter the correct
number.
If setup/cal was pressed after an incorrect number was entered, enter the code 251 followed
by the setup/cal key as a backspace command. Then enter the proper code and press
setup/cal to proceed.
5. When the script is finished, enter 0 then setup/cal. The scale will return to the normal weighing
mode.
CAUTION: To erase ALL scripts stored in the scale's memory, enter a —10 as the script identifier
number, followed by the setup/cal key. The scale will return to the normal weighing
mode.
To produce a label with Part # and APW as shown below, enter the following script. (s/c = setup/cal
key on the scale keypad)
SCRIPT - Part #: (ID 0 is default register) <CR><LF>
CODES - 80 s/c, 97 s/c, 114 s/c, 116 s/c, 32 s/c,
35 s/c, 58 s/c, 32 s/c 128 s/c, 13 s/c, 10 s/c
SCRIPT - APW: (APW register) (Units ltr) <CR><LF>
CODES - 65 s/c, 80 s/c, 87 s/c, 58 s/c, 32 s/c, 141 s/c,
32 s/c, 149 s/c, 13 s/c, 10 s/c (to add line feeds enter 10 s/c here)
0 s/c (to end script)
Each time the print key is pressed, the scale will output the above label and advance the printer to the
next label.
NOTE: A numeric part number or ID can be entered through the scale's keypad. Alphanumeric ID's
will have to be entered via a bar code wand, a stand-alone alphanumeric keypad attached to
the scale's RS-232 port or a PC connected to the scale.
TM
Setra Super Count Operator's Manual
Part #: 123-456
APW: +2.56789 G
27